

KLINGER®Graphite Laminate SLA
The pure graphite gasket with smooth sheet metal insert.
Combining pure exfoliated graphite with an aluminium foil insert, this gasket material promises smooth cutting and handling. Resistant to virtually any type of medium and highly compressible.
Basis composition
Expanded graphite and an aluminium insert.
Areas of application
Thanks to its graphite-based conformability characteristics, it is suitable for low bolt-load and damaged flange scenarios.
Industries
General industry / Chemical / Oil & Gas / Energy / Pulp & Paper / Marine / Automotive

Typical technical data for thickness 2 mm
Density of the graphite layer |
DIN 28090-2 | g/cm3 |
1.10 |
Purity of Graphite |
DIN 51903 | % | > 99.0 |
Metallic reinforcement |
Tanged metal Thickness Number of sheets |
mm | Aluminium 0.10 1 |
Compressibility |
ASTM F 36 A | % | 35-50 |
Recovery |
ASTM F 36 A | % | 10-15 |
Compression creep DIN 52913 | 16 h/ 50 MPa/ 300°C | MPa | ≥ 45 |
KLINGER cold/hot compression 50 MPa | Thickness decrease at 23°C Thickness decrease at 300°C |
% % |
40-50 |
Specific leak rate |
DIN 28090-2 | mg/ s x m°C | < 0.10 |
Chloride content of graphite layer |
DIN 28090-2 | ppm | ≤ 40 |
Function and durability
The performance and service life of KLINGER gaskets depend to a large extent on proper storage and fitting - factors beyond the manufactor’s control. We can, however, vouch for the excellent quality of our products. With this in mind, please also take note of our installation manual.
Downloads
Below you can find more product-related information.
Industries who we work with







